Skip to main content
Version: 4.0

Blue-Green Deployment

Blue-green deployment is a migration technique that can also be used as an upgrade strategy. The main idea is to set up a new environment (the "green" one) and switch to it when it is ready. Technically nothing is upgraded - the application just switch to a different environment, which might be using a different version, but can also differ in other aspects. For example, the same approach can be used to migrate to new hardware, while keeping the same version of RabbitMQ.

When that migration is done, the old ("blue") cluster is decommissioned (shut down, deleted). To simplify the switch, federated queues can be used to transfer enqueued messages from the "blue" to the "green" cluster.

Preparing the "green" Cluster​

After deploying a brand new "green" cluster, there are two steps to follow:

  • import definitions, e.g. exchanges, queues, bindings;
  • configure federation to later drain messages.

Importing definitions​

The procedure of definitions export/import is covered in the Backup guide. The "blue" is the source cluster and the "green" one is the target.

Configuring Queue Federation​

RabbitMQ Federation plugin makes it easy to move consumers from "blue" to "green", without disrupting message consumption or losing messages. The principle of federated queues is that the consumers now connected to "green" will get messages published to "blue" as long as there are no consumers in "blue" (local consumers take precedence).

Here is an example to federate all queues. In this example, the "blue" cluster is the upstream and the "green" one is the downstream.

First define the upstream on "green" and point it to "blue":

rabbitmqctl set_parameter federation-upstream blue \
  '{"uri":"amqp://node-in-blue-cluster"}'

Then define a policy matching all queues which configure blue as the upstream:

rabbitmqctl set_policy --apply-to queues blue-green-migration ".*" \
  '{"federation-upstream":"blue"}'

Please read the guides linked above and the federation reference for further details.

Migrate Consumers Over​

You can now switch your consumers to use the new "green" cluster. To achieve that, reconfigure your load balancer or your consumer applications, depending on your setup. The upgrade guide covers some client features which enable them to switch between nodes.

At that point, your producers are still publishing to "blue", but thanks to the federation plugin, message are transferred to consumers connected to "green".

Drain Messages​

The next step would be to switch producers to "green" as well. However, you may still have a backlog of messages in "blue". The federation plugin doesn't help here because it doesn't move messages, it only allows remote consumers to dequeue messages.

In case of a large backlog, use the Shovel plugin on "green" to really drain messages in "blue". This would require doing something like the following for each queue with a backlog:

rabbitmqctl set_parameter shovel drain-blue \
'{"src-protocol": "amqp091", "src-uri": "amqp://node-in-blue-cluster", \
"src-queue": "queue1", "dest-protocol": "amqp091", \
"dest-uri": "amqp://", "dest-queue": "queue1"}'

Migrate Producers Over​

Once the queues in "blue" are almost empty, you can stop producers. If message ordering is important to you, you should still wait a bit more so that the federation or shovel plugins finish to drain the queues on "blue".

When they are empty, reconfigure your producers like you did for the consumers and start them again. At this point, everything is moved to the "green" cluster.

Decommission the "blue" Cluster​

You are now free to shutdown the nodes in the "blue" cluster.

Real-world Example​

Dan Baskette, Gareth Smith and Claude Devarenne of Pivotal published an article about this method where producers and consumers are CloudFoundry applications. The article is very detailed and uses diagrams to describe the procedure. They also made a video to show it in action.

This guide is inspired by their great work.